Two-step descent control of fire roller shutter

Two‑stage drop of fire roller shutters is the core logic of fire alarm linkage, mainly applied to fire roller shutters on evacuation routes. Unlike shutters in non‑evacuation areas that close fully in one stroke, the two‑stage drop is designed to give an early warning first and then block fire and smoke. It balances personnel evacuation and fire separation. This function is prone to faults during on‑site commissioning, routine inspection and acceptance. Mastering operating procedures and troubleshooting helps avoid acceptance failure and function breakdown in fire scenarios.
Fire acceptance shall comply with relevant codes. Regularly inspect wiring, limit switches, detectors and control boxes to eliminate hidden risks. Ensure the shutter operates as programmed in a fire, reserving time for evacuation and forming fire separation reliably to deliver the intended fire protection performance.
On-site commissioning of the two-stage drop function
Prior checks are required before on‑site commissioning. Verify correct wiring and stable power supply for the shutter motor, control box, limit switches, smoke/heat detectors and fire alarm host, with no short circuits or loose connections. Start with manual tests: use the buttons on the control box to check responsive up, down and stop functions. Test the manual pull chain for smooth lifting and lowering without jamming or abnormal noise. Proceed with independent linkage tests: trigger the smoke detector alone. The shutter shall stop at the 1.8 m limit position, and the control box sends a half‑drop feedback signal to the fire host. Then trigger the heat detector; the shutter continues descending to the floor and sends a full‑drop feedback. After commissioning, recheck the 1.8 m limit position. The limit block shall be firmly fastened to prevent displacement by vibration.

Key Practical Points for Routine Inspection of Fire Roller Shutters
Test the two‑stage linkage periodically; do not only run one‑shot full‑drop tests. Check that guide rails are free of debris, the curtain is intact without tearing or fraying, and rail seals are in good condition. Keep motors and control boxes moisture‑proof and dust‑proof. No goods or equipment shall be stacked under shutters on evacuation routes. Warning signs shall be installed to prevent jamming and motor overload. Operators shall be familiar with emergency operation: if linkage fails, use the control box buttons to stop or lower the shutter, or activate the manual release device in an emergency, and keep records accordingly.
